Hi
I'm trying to set up an HP2100tn laserjet with a jetdirect 610N network card, on a home system, going through my router/modem combination. I'm running hardy.
When I print a test page directly from the printer, the jetdirect info page says "I/O Card Ready", but further down under the TCP/IP it says:
Status: Initializing
BOOTP/DCHP IN PROGRESS
Host Name: Not Specified
IP Address: 0.0.0.0
everything below that says 0.0.0.0 or "not specified". I've reset the printer, and powered it down, but no change.
I've installed BOOTP and PUMP to see if they will assign an IP address, but they don't.
I've used the CUPS online printer setup, and it will show the printer with an "idle, accepting jobs, published" status until I try to do a test print through CUPS, then it changes the status to "stopped"
Any ideas?
I'm trying to set up an HP2100tn laserjet with a jetdirect 610N network card, on a home system, going through my router/modem combination. I'm running hardy.
When I print a test page directly from the printer, the jetdirect info page says "I/O Card Ready", but further down under the TCP/IP it says:
Status: Initializing
BOOTP/DCHP IN PROGRESS
Host Name: Not Specified
IP Address: 0.0.0.0
everything below that says 0.0.0.0 or "not specified". I've reset the printer, and powered it down, but no change.
I've installed BOOTP and PUMP to see if they will assign an IP address, but they don't.
I've used the CUPS online printer setup, and it will show the printer with an "idle, accepting jobs, published" status until I try to do a test print through CUPS, then it changes the status to "stopped"
Any ideas?
Comment