Hey All,
OK please help. Last night my wireless adaptor was working just fine. Shut down using the "log off" and "shut down". Got up this morning and nothing. I wouldn't connect to the network. So I checked the other computers in the house to make sure it wasn't the router. And each one connected just fine, using the preloaded OS. I checked my settings and from what I can tell nothing has changed (but I'll admit I don't remember 100% what they said before). I had to hard wire it. So I disabled and enabled the driver to see if that would help, but I think I made it worst. Cause it tells me "No Active Device". But in "Network Manager" it tells me eth1 is active. I checked
and my card is there. If I check the "Restricted Drivers" it shows "In Use" and "Enabled". So I'm at a loss here.
I did not run any kind of update. Just shut it off and then turned it back on this morning.
Please Help!!!
Thanks,
James
OK please help. Last night my wireless adaptor was working just fine. Shut down using the "log off" and "shut down". Got up this morning and nothing. I wouldn't connect to the network. So I checked the other computers in the house to make sure it wasn't the router. And each one connected just fine, using the preloaded OS. I checked my settings and from what I can tell nothing has changed (but I'll admit I don't remember 100% what they said before). I had to hard wire it. So I disabled and enabled the driver to see if that would help, but I think I made it worst. Cause it tells me "No Active Device". But in "Network Manager" it tells me eth1 is active. I checked
Code:
lspic -v
I did not run any kind of update. Just shut it off and then turned it back on this morning.
Please Help!!!
Thanks,
James