Hello,
My Huawei 4g usb-modem was fine 24 hrs ago and now no internet.
The Hi-Link page , which is the official Huawei modem page is saying that i am connected.
I try to navigate but the ( i am working sign ) just keeps on circling.
The page tries to load but can not .
I do not understand what is happening here.
My sim card is ok , take it out the dongle and into mobile phone to make a call - no problems there....
What i did to get the dongle to work initially was :
Basically, this is how i installed the dongle but it`s not working.
Have also tried to reset the dongle , using different apn settings , user name , password etc , without success.
Installed os on another drive but unable to connect .
Obviously doing something wrong, but what.
Need some help again , many thanks.
My Huawei 4g usb-modem was fine 24 hrs ago and now no internet.
The Hi-Link page , which is the official Huawei modem page is saying that i am connected.
I try to navigate but the ( i am working sign ) just keeps on circling.
The page tries to load but can not .
I do not understand what is happening here.
My sim card is ok , take it out the dongle and into mobile phone to make a call - no problems there....
What i did to get the dongle to work initially was :
Code:
- Install usb modeswitch : sudo apt-get -y install usb-modeswitch - Turn the dongle from being identified from being a card reader to a modem with : sudo usb_modeswitch -v 12d1 -p 1f01 -M '5553424312345678000000000000001106200000010100010 0000000000000' - Retrieve an IP address from the modem : sudo dhclient -v eth2 - Confirm the default gateway points to the modem : sudo ip route show | grep default - Make sure /etc/resolv.conf contains a valid nameserver if you can’t resolve domain names : Not sure on this one ! - Switch the Huawei into a modem at boot time, create /etc/udev/rules.d/70-usb-modeswitch.rules and insert this line: ACTION=="add", SUBSYSTEM=="usb", ATTRS{idVendor}=="12d1", ATTRS{idProduct}=="1f01", RUN+="/usr/sbin/usb_modeswitch -v 12d1 -p 1f01 -M '5553424312345678000000000000001106200000010100010 0000000000000'" - Finally, automatically add a valid nameserver in /etc/resolv.conf when eth2 comes up, adding these lines to /etc/dhcp/dhclient.conf: interface "eth1" { prepend domain-name-servers 8.8.8.8; request subnet-mask, broadcast-address, time-offset, routers, domain-name, domain-name-servers, domain-search, host-name, dhcp6.name-servers, dhcp6.domain-search, netbios-name-servers, netbios-scope, interface-mtu, rfc3442-classless-static-routes, ntp-servers, dhcp6.fqdn, dhcp6.sntp-servers; require routers, domain-name-servers; }
Have also tried to reset the dongle , using different apn settings , user name , password etc , without success.
Installed os on another drive but unable to connect .
Obviously doing something wrong, but what.
Need some help again , many thanks.
Comment