I don't know if this is a place for this, but I hope it is. If not mods are free to move it to forum that you thing is more relevant.
This is more of an logical puzzle or something like that, so if you like solving puzzles this topic is for you!
I had an "old" computer:
Gigabyte 7VAXP mainboard
ATI 8500 AllInWonder
756 MB RAM
4GB Maxtor disk
Whatever I throw at it, it hangs, stops somewhere during installation process or it refuses to boot it once I finish with an install.
So this are the systems that I wanted to install:
Ubuntu 7.10, DSL and PC-BSD don't even boot.
OpenSolaris: It demands a password after bootloading, it shouldn't. I think it's a problem that it can't access the disk / RAM to load the kernel on it.
Windows: It gets to the start of setup (after all the modules were loaded) and then it goes BSOD:
It might be an Hard drive problem, but I (well technically it was my father) did put the previous disk in it and the same problems occurred.
Arch did load, but I was to lazy to go through the whole installation process...
PCLinuxOS: loaded, booted, installed, restarted, booted again died when X should have start (totally I tried ctrl-altF1 and ctrl-alt-backspace)
So Any ideas?
Any other system that I should try??
And please don't say Kubuntu (it probably wouldn't but just like Ubuntu) but this PC would be mostly used by my father who would use it to play CDs on it, and the KDE4 doesn't ask you what to it just mounts them...
This is more of an logical puzzle or something like that, so if you like solving puzzles this topic is for you!
I had an "old" computer:
Gigabyte 7VAXP mainboard
ATI 8500 AllInWonder
756 MB RAM
4GB Maxtor disk
Whatever I throw at it, it hangs, stops somewhere during installation process or it refuses to boot it once I finish with an install.
So this are the systems that I wanted to install:
Ubuntu 7.10, DSL and PC-BSD don't even boot.
OpenSolaris: It demands a password after bootloading, it shouldn't. I think it's a problem that it can't access the disk / RAM to load the kernel on it.
Windows: It gets to the start of setup (after all the modules were loaded) and then it goes BSOD:
Code:
....Check for virus, if your Hard Drive is installed correctly... STOP: 0x0000007B (0XF797A524, 0XC0000034, 0X00000000, 0X00000000)
Arch did load, but I was to lazy to go through the whole installation process...
PCLinuxOS: loaded, booted, installed, restarted, booted again died when X should have start (totally I tried ctrl-altF1 and ctrl-alt-backspace)
So Any ideas?
Any other system that I should try??
And please don't say Kubuntu (it probably wouldn't but just like Ubuntu) but this PC would be mostly used by my father who would use it to play CDs on it, and the KDE4 doesn't ask you what to it just mounts them...
Comment