is it possible to make work my irda ?

[computador]

I tried to make work my irda but I'm not able to.


thanks

[computador]

Re: is it possible to make work my irda ?


My dmesg :

irda_init()
[ 33.684494] NET: Registered protocol family 23
[ 33.731731] Detected unconfigured Toshiba laptop with Intel 8281DBM LPC bridge SMSC IrDA chip, pre-configuring device.
[ 33.731737] Setting up Intel 82801 controller and SMSC device
[ 33.731753] Detected Chip id: 0x7a, setting up registers...
[ 33.731840] found SMC SuperIO Chip (devid=0x7a rev=00 base=0x002e): LPC47N227
[ 33.731856] smsc_superio_flat(): fir: 0x130, sir: 0x3f8, dma: 03, irq: 3, mode: 0x0e
[ 33.731870] SMsC IrDA Controller found
[ 33.731872] IrCC version 2.0, firport 0x130, sirport 0x3f8 dma=3, irq=3
[ 33.731924] smsc_ircc_set_sir_speed(), Setting speed to: 9600
[ 33.731937] No transceiver found. Defaulting to Fast pin select
[ 33.732738] IrDA: Registered device irda0

Help me guide ....

[mchuskie]

Re: is it possible to make work my irda ?

So what are you doing to "make work" your IR port? What do you want it to do that it is not doing?

[Sigid]

Re: is it possible to make work my irda ?

Hello

I'm new to linux and just manage to install Kubuntu 7.10 few days ago in an old ECS Desknote.

First, the built-in conexant modem not working, but since hsfmodem driver installed, it works just fine. My problem is that I can' get the built-in infra red device work. I've installed irda-utils but still don't work.

Do I also need to install any driver for this irda to work, thanks