Announcement

Collapse
No announcement yet.

Konqueror does not work after switching from eth1 to eth0

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Konqueror does not work after switching from eth1 to eth0

    Hello everybody.

    I got strange problem with Konqueror after upgrading to 7.04.
    When I switching from eth1 (wi-fi/dhcp) to eth0 (wire/dhcp), konqueror stops working with http. (after 'sudo ifup eth0' because eth0 is disabled by default).
    Everything other works just fine (firefox, ping, traceroute, apt-get etc).
    ifconfig looks ok (only eth0 presents) and route -n show normal table.

    I even tried local http proxy but it did not help. In any case Konqueor wrote:
    An error occurred while loading http://kubuntu.com/:
    Could not connect to host http://kubuntu.com/.
    (I tried IP instead of dns name, it does not help)

    'killall konqueror' does not work too.

    So I'm using firefox now. But when i'll switch to eth1 again, konqueror will work again.

    Any ideas?
Working...
X