Installation Woes

[Andrew1963]

I am having problems installing Kubuntu. When I try to run the Installation program, I can enter the location and language details, but when I try to proceed, the text becomes outsize to an extreme degree and becomes unreadable. Please

My system is a Packard Bell Easy Note. Please find the hardware details of this system below my sig.

Anyone know why I am unable to use the graphical installer ?

Andrew

11: udi = '/org/freedesktop/Hal/devices/storage_serial_5PJ2NZ3W'
block.device = '/dev/hda'
block.is_volume = false
block.major = 3 (0x3)
block.minor = 0 (0x0)
block.storage_device = '/org/freedesktop/Hal/devices/storage_serial_5PJ2NZ3W'
info.capabilities = { 'storage', 'block' }
info.category = 'storage'
info.parent = '/org/freedesktop/Hal/devices/pci_1106_571_ide_0_0'
info.product = 'ST950814A'
info.udi = '/org/freedesktop/Hal/devices/storage_serial_5PJ2NZ3W'
linux.hotplug_type = 3 (0x3)
linux.sysfs_path = '/sys/block/hda'
linux.sysfs_path_device = '/sys/block/hda'
storage.automount_enabled_hint = true
storage.bus = 'ide'
storage.drive_type = 'disk'
storage.firmware_version = '3.06'
storage.hotpluggable = false
storage.media_check_enabled = false
storage.model = 'ST950814A'
storage.no_partitions_hint = false
storage.physical_device = '/org/freedesktop/Hal/devices/pci_1106_571_ide_0_0'
storage.policy.should_mount = false
storage.removable = false
storage.requires_eject = false
storage.serial = '5PJ2NZ3W'
storage.vendor = ''
volume.ignore = true

12: udi = '/org/freedesktop/Hal/devices/storage_model_Slimtype_DVDRW_SOSW_833S'
block.device = '/dev/hdc'
block.is_volume = false
block.major = 22 (0x16)
block.minor = 0 (0x0)
block.storage_device = '/org/freedesktop/Hal/devices/storage_model_Slimtype_DVDRW_SOSW_833S'
info.addons = { 'hald-addon-storage' }
info.callouts.add = { 'hal-resmgr' }
info.callouts.remove = { 'hal-resmgr' }
info.capabilities = { 'storage', 'block', 'storage.cdrom' }
info.category = 'storage'
info.parent = '/org/freedesktop/Hal/devices/pci_1106_571_ide_1_0'
info.product = 'Slimtype DVDRW SOSW-833S'
info.udi = '/org/freedesktop/Hal/devices/storage_model_Slimtype_DVDRW_SOSW_833S'
linux.hotplug_type = 3 (0x3)
linux.sysfs_path = '/sys/block/hdc'
linux.sysfs_path_device = '/sys/block/hdc'
resmgr.class = 'cdrom'
storage.automount_enabled_hint = true
storage.bus = 'ide'
storage.cdrom.cdr = true
storage.cdrom.cdrw = true
storage.cdrom.dvd = true
storage.cdrom.dvdplusr = true
storage.cdrom.dvdplusrdl = true
storage.cdrom.dvdplusrw = true
storage.cdrom.dvdplusrwdl = false
storage.cdrom.dvdr = true
storage.cdrom.dvdram = false
storage.cdrom.dvdrw = true
storage.cdrom.read_speed = 4234 (0x108a)
storage.cdrom.support_media_changed = true
storage.cdrom.write_speed = 4234 (0x108a)
storage.cdrom.write_speeds = { '4234' }
storage.drive_type = 'cdrom'
storage.firmware_version = 'V9S2'
storage.hotpluggable = false
storage.media_check_enabled = true
storage.model = 'Slimtype DVDRW SOSW-833S'
storage.no_partitions_hint = true
storage.physical_device = '/org/freedesktop/Hal/devices/pci_1106_571_ide_1_0'
storage.policy.desired_mount_point = 'dvdrecorder'
storage.policy.mount_filesystem = 'auto'
storage.policy.should_mount = true
storage.removable = true
storage.requires_eject = true
storage.vendor = ''

46: None 00.0: 10000 Monitor
[Created at fb.70]
Unique ID: rdCR.EY_qmtb9YY0
Hardware Class: monitor
Model: "Generic Monitor"
Vendor: "Generic"
Device: "Monitor"
Resolution: 1024x768@76Hz
Driver Info #0:
Max. Resolution: 1024x768
Vert. Sync Range: 50-90 Hz
Hor. Sync Range: 31-61 kHz
Config Status: cfg=no, avail=yes, need=no, active=unknown