Configure wireless

[new]

i have installed the driver in this way

linux@linux:~$ sudo su
Password:
root@linux:/home/linux# cd /home/linux/Desktop/999
root@linux:/home/linux/Desktop/999# ndiswrapper -i USRMAXG.inf
Installing usrmaxg
root@linux:/home/linux/Desktop/999# ndiswrapper -l
Installed ndis drivers:
usrmaxg driver present, hardware present
root@linux:/home/linux/Desktop/999# sudo modprobe ndiswrapper
root@linux:/home/linux/Desktop/999#

but now i don't know how configure it

this are my router setting:

linux@linux:~$ iwconfig
lo no wireless extensions.

eth0 IEEE 802.11b/g ESSIDff/any Nickname:"Broadcom 4318"
Mode:Managed Access Point: Invalid Bit Rate=1 Mb/s
RTS thrff Fragment thrff
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

-----------------------------------------------------------------------------

Line rate - upstream: 352 Kbps
Line rate - downstream: 2464 Kbps
LAN IP address: 192.168.1.1
WAN IP address: View
Default gateway: 192.168.100.1
Primary DNS server: 85.37.17.4
Secondary DNS server: 85.38.28.70

-------------------------------------------------------------------------------


# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

# The loopback network interface
auto lo
iface lo inet loopback
address 127.0.0.1
netmask 255.0.0.0

iface eth0 inet bootp

auto eth0

[a_l_a_n]

Re: Configure wireless

Install Wifi-Radar ... its a convenient way to set the ESSID and WEP/WPA keys ...