I changed from Ubuntu to Kubuntu on a clean install. Kubuntu originally recognised the Wireless card in Network Settings (although I hadn't got it working! - I was going to use the same methodology as had got it working under Ubuntu) however I can now only see eth0.
The following happens using ifup
mad@mad-desktop:~$ sudo ifup wlan0
Error for wireless request "Set ESSID" (8B1A) :
SET failed on device wlan0 ; No such device.
Internet Systems Consortium DHCP Client V3.0.3
Copyright 2004-2005 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/products/DHCP
SIOCSIFADDR: No such device
wlan0: ERROR while getting interface flags: No such device
wlan0: ERROR while getting interface flags: No such device
Bind socket to interface: No such device
Failed to bring up wlan0.
Yet the following extract from running lshw shows the card is at least recognised to some extent!
*-network:0 UNCLAIMED
description: Network controller
product: ACX 111 54Mbps Wireless Interface
vendor: Texas Instruments
physical id: 4
bus info: pci@02:04.0
version: 00
width: 32 bits
clock: 33MHz
capabilities: cap_list
resources: iomemory:fb028000-fb029fff iomemory:fb000000-fb01ffff irq:169
Any suggestions to help me out would be appreciated.
Thanks (and treat me gently - I'm one of those ignorant newbies trying to ditch Bill)
The following happens using ifup
mad@mad-desktop:~$ sudo ifup wlan0
Error for wireless request "Set ESSID" (8B1A) :
SET failed on device wlan0 ; No such device.
Internet Systems Consortium DHCP Client V3.0.3
Copyright 2004-2005 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/products/DHCP
SIOCSIFADDR: No such device
wlan0: ERROR while getting interface flags: No such device
wlan0: ERROR while getting interface flags: No such device
Bind socket to interface: No such device
Failed to bring up wlan0.
Yet the following extract from running lshw shows the card is at least recognised to some extent!
*-network:0 UNCLAIMED
description: Network controller
product: ACX 111 54Mbps Wireless Interface
vendor: Texas Instruments
physical id: 4
bus info: pci@02:04.0
version: 00
width: 32 bits
clock: 33MHz
capabilities: cap_list
resources: iomemory:fb028000-fb029fff iomemory:fb000000-fb01ffff irq:169
Any suggestions to help me out would be appreciated.
Thanks (and treat me gently - I'm one of those ignorant newbies trying to ditch Bill)
Comment