Hi!
I just installed dapper on my computer.
I discoverd a "bug" in the installation process.
When I started the computer with the live cd and pressed the install-file on the desktop a installation process started.
In the installation process theres a step where you can manually create your partitions.
I choosed that and made my partitions as I wanted them and klicked on confirm.
But when I came to the next step (where you choose the mountpoint) my partitions wasn't there.
I tried like crasy but they never came up.
Untill I canceld the installation and started it again and did the same process (exept that I didn't do anything with the partitions because they already was like I wanted them).
Then when I came to the step where I choose the mountpoint I found all of my partitions.
So with my installation cd I had to restart the installation process after I had organised my partiotion to be able to mount them.
Is this a known bug?
// Johan
I just installed dapper on my computer.
I discoverd a "bug" in the installation process.
When I started the computer with the live cd and pressed the install-file on the desktop a installation process started.
In the installation process theres a step where you can manually create your partitions.
I choosed that and made my partitions as I wanted them and klicked on confirm.
But when I came to the next step (where you choose the mountpoint) my partitions wasn't there.
I tried like crasy but they never came up.
Untill I canceld the installation and started it again and did the same process (exept that I didn't do anything with the partitions because they already was like I wanted them).
Then when I came to the step where I choose the mountpoint I found all of my partitions.
So with my installation cd I had to restart the installation process after I had organised my partiotion to be able to mount them.
Is this a known bug?
// Johan