Cannot boot using lilo

[Paulo]

I tried to boot using lilo, the boot manager I use to use.

So, I did:

Installed lilo from the new kubuntu/dapper 4 system
using apt-get (adept does not work - see another post
in this forum). I did not run lilo here.

Rebooted by current Gentoo installation and entered the
following in my lilo.conf:

image = /SDB6/boot/vmlinuz-2.6.15-15-386
root = /dev/sdb6
label = "Kubuntu"
read-only
append = "ro quiet splash"
initrd = /SDB6/boot/initrd.img-2.6.15-15-386

Note: /SDB6 is the partition /dev/hdb6, where the new
kubuntu/dapper 4 system was installed.

After running lilo and rebooting I got the usual
splash but the system hangs after the second message
"Mounting root filesystem" blanking the screeen and
displaying a blinking cursor on the upper left corner.
Needed to type CTRL+ALT+DEL.

Thanks for any help/comments.

[awakatanka]

Re: Cannot boot using lilo

http://justlinux.com/forum/showthrea...hreadid=139791

Maybe it helps you.