I just did a fresh install of Kubuntu 6.06 and it won't connect to the internet using my WG311v2 wireless PCI card. In the network settings my wlan0 shows up enabled. Under the KInfocenter's network info it does not appear. As for the rest of what I've found it's as follows:
wlan0 No scan results
caudata@caudata-desktop:~$ iwconfig wlan0
wlan0 IEEE 802.11b+/g+ ESSID:"STA4CD165" Nickname:"acx v0.3.21"
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Bit Rate:54 Mb/s Tx-Power=15 dBm Sensitivity=1/3
Retry min limit:7 RTS thrff
Power Managementff
Link Quality=31/100 Signal level=4/100 Noise level=0/100
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
caudata@caudata-desktop:~$ ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:0F:B5:4C1:65
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:74 Base address:0xe000
I can't claim to know exactly what all of this means but obviously it's not finding the wireless access point. The iwlist wlan0 scan gives back no scan results. Anyway if anyone has any suggestions for getting the connection up and running let me know. I appreciate any help that can be provided, later!
wlan0 No scan results
caudata@caudata-desktop:~$ iwconfig wlan0
wlan0 IEEE 802.11b+/g+ ESSID:"STA4CD165" Nickname:"acx v0.3.21"
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Bit Rate:54 Mb/s Tx-Power=15 dBm Sensitivity=1/3
Retry min limit:7 RTS thrff
Power Managementff
Link Quality=31/100 Signal level=4/100 Noise level=0/100
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
caudata@caudata-desktop:~$ ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:0F:B5:4C1:65
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:74 Base address:0xe000
I can't claim to know exactly what all of this means but obviously it's not finding the wireless access point. The iwlist wlan0 scan gives back no scan results. Anyway if anyone has any suggestions for getting the connection up and running let me know. I appreciate any help that can be provided, later!
Comment