Hi everyone! I'm new with Linux and thus also Kubuntu but am very pleased with what I've been seeing so far!
There's just one problem with my installation, I can't configure my 9250 properly! I downloaded the drivers from www.ATI.com and installed them with no hastle logged in as root as mentioned in the instructions from www.ATI.com but when I try ATI control in the K-menu I receive the following:
Driver does not provide the FireGL X11 extensions!
Panel components will operate only partially.
here's what aticonfig -initial has to say:
p35@p35-desktop:~$ aticonfig --initial
Uninitialised file found, configuring.
generate load 'dri' module
Using /etc/X11/xorg.conf
Saved back-up to /etc/X11/xorg.conf.original-0
aticonfig: Writing to '/etc/X11/xorg.conf' failed. Bad file descriptor.
I was under the impression that the correct command should be:
aticonfig -initial but that recieves this:
p35@p35-desktop:~$ aticonfig -initial
Warning: Could not find configuration file
Please copy configuration file template to /etc/X11
p35@p35-desktop:~$
Can anyone help?
There's just one problem with my installation, I can't configure my 9250 properly! I downloaded the drivers from www.ATI.com and installed them with no hastle logged in as root as mentioned in the instructions from www.ATI.com but when I try ATI control in the K-menu I receive the following:
Driver does not provide the FireGL X11 extensions!
Panel components will operate only partially.
here's what aticonfig -initial has to say:
p35@p35-desktop:~$ aticonfig --initial
Uninitialised file found, configuring.
generate load 'dri' module
Using /etc/X11/xorg.conf
Saved back-up to /etc/X11/xorg.conf.original-0
aticonfig: Writing to '/etc/X11/xorg.conf' failed. Bad file descriptor.
I was under the impression that the correct command should be:
aticonfig -initial but that recieves this:
p35@p35-desktop:~$ aticonfig -initial
Warning: Could not find configuration file
Please copy configuration file template to /etc/X11
p35@p35-desktop:~$
Can anyone help?
Comment