Announcement

Collapse
No announcement yet.

Alfa WiFi Aadaptor AWUS036NHA

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    [SOLVED] Alfa WiFi Aadaptor AWUS036NHA

    Hi All,

    I am using Alfa WiFi Adaptor AWUS036NHA (Atheros AR9271 Chipset) on my desktop running Kubuntu 18.04.1.
    Works great and getting 36MB/s out of it which is super.
    However, if I do not use it for a while it seems to go to sleep, and I have to disconnect and reconnect to the network to get it working again.
    I have disabled power saving.
    iwconfig looks like
    Mode:Managed Frequency:2.427 GHz Access Point: A0:BD:CD:17:9CA
    Bit Rate=72.2 Mb/s Tx-Power=20 dBm
    Retry short limit:7 RTS thrff Fragment thrff
    Power Managementff
    Link Quality=58/70 Signal level=-52 dBm
    Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
    Tx excessive retries:9 Invalid misc:122 Missed beacon:0
    Any ideas anyone ??
    Last edited by Flip the Switch; Oct 25, 2018, 03:43 PM.

    #2
    Are you using the ath9k driver?
    "A nation that is afraid to let its people judge the truth and falsehood in an open market is a nation that is afraid of its people.”
    – John F. Kennedy, February 26, 1962.

    Comment


      #3
      An easy way to check that is with the inxi command line utility.
      Code:
      inxi -n
      The next brick house on the left
      Intel i7 11th Gen | 16GB | 1TB | KDE Plasma 5.27.11​| Kubuntu 24.04 | 6.8.0-31-generic



      Comment


        #4
        Hi Guys,
        Thanks for the response.
        inxi -n shows
        Card-2: Atheros AR9271 802.11n driver: ath9k_htc
        IF: wlx00c0ca9768de state: N/A mac: N/A

        Comment


          #5
          modinfo ath9k_htc gives the following info:
          Code:
          name:           ath9k_htc
          vermagic:       4.15.0-39-generic SMP mod_unload 
          signat:         PKCS#7
          signer:         
          sig_key:        
          sig_hashalgo:   md4
          parm:           debug:Debugging mask (uint)
          parm:           nohwcrypt:Disable hardware encryption (int)
          parm:           btcoex_enable:Enable wifi-BT coexistence (int)
          parm:           ps_enable:Enable WLAN PowerSave (int)
          parm:           use_dev_fw:Use development FW version (int)
          parm:           blink:Enable LED blink on activity (int)
          Open a Konsole and issue
          sudo touch /etc/modprobe.d/ath9k_htc.conf
          Then, close the Konsole and browse to that file with Dolphin.
          Right mouse on it and open it with Kate.
          In ath9k_htc.conf put
          option ath9k_htc nohwcrypt=1
          option ath9k_htc ps_enable=0

          and save the file. You will be asked for your account password. Enter it and press OK.
          Reboot.
          "A nation that is afraid to let its people judge the truth and falsehood in an open market is a nation that is afraid of its people.”
          – John F. Kennedy, February 26, 1962.

          Comment


            #6
            Hi GreyGeek.

            Your solution seems to have done the trick.
            I have only had two failure to awaken's in about the last ten hours, so I am more than chuffed with the result.
            Many thanks for your help.

            Comment

            Working...
            X