Satip configuration problem

[kdeuser]

Hello,

My install of satip is not going well and need help on it.

- My os is Trusty 14.04 32 bit
- Trying to use tvheadend but not working too good.
- I get stuck on the ( use your ip address of the server ). How would you do that ?

I ran a ifconfig and this is the output :

lo        Link encap:Local Loopback  
       inet addr:127.0.0.1  Mask:255.0.0.0
       inet6 addr: ::1/128 Scope:Host
       UP LOOPBACK RUNNING  MTU:65536  Metric:1
       RX packets:2726 errors:0 dropped:0 overruns:0 frame:0
       TX packets:2726 errors:0 dropped:0 overruns:0 carrier:0
       collisions:0 txqueuelen:0 
       RX bytes:9365759 (9.3 MB)  TX bytes:9365759 (9.3 MB)

...and the second address :

eth1      Link encap:Ethernet  HWaddr 00:e0:f4:1f:56:52  
       inet addr:192.168.1.33  Bcast:192.168.1.255  Mask:255.255.255.0
       inet6 addr: fe80::2e0:f4ff:fe1f:5652/64 Scope:Link
       UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
       RX packets:3439 errors:0 dropped:0 overruns:0 frame:0
       TX packets:3711 errors:0 dropped:0 overruns:0 carrier:0
       collisions:0 txqueuelen:1000 
       RX bytes:1410041 (1.4 MB)  TX bytes:545284 (545.2 KB)

So which address do i use ?

It doesn´t matter which one i put into browser i get unable to connect every time.

Http://127.0.0.1:9981
Http://192.168.1.33:9981

They tell me a web interface should appear , i can´t see one though.

I´d just like to see that interface .

Help please and thanks.