Hello,
yesterday i updated some packages on my kubuntu 12.10. I got a strange error message like "your linux configuration may not be working" but i didn't pay attention at all. This morning in my grub i found only memory test and windows. So i repaired with the boot repair and i got my kubuntu login back. Wow, i thought, it was easy! In stead, during the startup a power management error appears saying that it can't load. Then i have no access to the network configuration. I use cable connection to an ethernet switch that works for sure.
This is the link to my boot repair log:
http://paste.ubuntu.com/6503660/
i tried to run ifconfig -a:
so it looks like eth0 is still there (actually i thought since boot repair used it)
Well, hope someone can help me out with this! thanks in advance
yesterday i updated some packages on my kubuntu 12.10. I got a strange error message like "your linux configuration may not be working" but i didn't pay attention at all. This morning in my grub i found only memory test and windows. So i repaired with the boot repair and i got my kubuntu login back. Wow, i thought, it was easy! In stead, during the startup a power management error appears saying that it can't load. Then i have no access to the network configuration. I use cable connection to an ethernet switch that works for sure.
This is the link to my boot repair log:
http://paste.ubuntu.com/6503660/
i tried to run ifconfig -a:
Code:
eth0 Link encap:Ethernet HWaddr somenumbers BROADCAST MULTICAST MTU:1500 Metric:1 RX and TX packets, errors, dropped, overruns: 0 Interrupt:20 Memory: f7c00000-f7c20000 lo Link encap:Local loopback ...
Well, hope someone can help me out with this! thanks in advance